Home › Engine / Hybrid System › 1BZ-FPE (ENGINE CONTROL) › ELECTRONIC CONTROLLED CARBURETOR SYSTEM › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073136 1BZ-FPE ENGINE CONTROL _0355837 ELECTRONIC CONTROLLED CARBURETOR SYSTEM J

1BZ-FPE ENGINE CONTROL  ELECTRONIC CONTROLLED CARBURETOR SYSTEM  Back-up Power Source Circuit  


DESCRIPTION

Battery voltage is supplied to terminal BATT of the engine ECU even when the ignition switch is OFF for the use of the diagnostic trouble code memory, air-fuel ratio adaptive control value memory, etc.

WIRING DIAGRAM

A401599E01
0.75,3.969 1.333,4.177 0.583,0.208 10 false Battery 0.573,2.833 1.26,3.104 0.688,0.271 10 false FL MAIN 0.563,2.042 1.604,2.26 1.042,0.219 10 false R/B NO. 2-B 1.594,1.365 1.865,1.583 0.271,0.219 10 false P/I 2.698,1.375 3.438,1.604 0.74,0.229 10 false EFI-MAIN 5.729,1 5.917,1.208 0.188,0.208 10 false 1 5.667,1.198 5.99,1.396 0.323,0.198 10 false A51 5.688,1.885 5.927,2.083 0.24,0.198 10 false 24 5.656,2.094 6,2.313 0.344,0.219 10 false B76 6,1.188 6.427,1.427 0.427,0.24 10 false BATT 6.01,2.083 6.333,2.302 0.323,0.219 10 false E1 6.115,3.125 6.948,3.323 0.833,0.198 10 false Engine ECU

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.Check voltage between terminal BATT of engine ECU connector and body ground.
A401600E01
2.448,0.323 3.01,0.938 true 0.583,0.167 1.083,0.365 0.5,0.198 10 false LOCK 2.094,0.188 2.5,0.396 0.406,0.208 10 false BATT 1.76,1.906 2,2.115 0.24,0.208 10 false (-) 2.427,1.896 2.677,2.104 0.25,0.208 10 false (+)

PREPARATION:

Remove the side trim bracket.

CHECK:

Measure the voltage between terminal BATT of the engine ECU connector and body ground.

OK:

Voltage: 9 -14 V


Result:
Proceed to
OK
NG



OK

2.Are DTCs still in the memory when ignition switch is turned OFF?

NG

Check and repair harness or connector between engine ECU and battery.

2.Are DTCs still in the memory when ignition switch is turned OFF?
Result:
Proceed to
YES
NO



YES

Proceed to next circuit inspection shown on problem symptoms table.

NO