Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM D

N04C-UH ENGINE CONTROL  ECD SYSTEM  INITIALIZATION  


SUPPLY PUMP INITIALIZATION PROCEDURE


HINT:

After replacing the injection or supply pump assembly and/or the ECM, perform the Supply Pump Initialization.

·

The ECM's learned values must be initialized. The engine can be initialized through the intelligent tester.

·

If the engine starts normally, initialization is not necessary. Perform steps A (See procedure "A") and B (See procedure "B") only.



a.
A280985

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Utility / Supply Pump Initialization.


e.

Press "Next".


f.
A280986

Press "Next".


g.
A280987

Press "Exit".


h.

Start the engine to check if initialization is complete.

If the engine cannot be started, repeat the initialization procedures from the beginning (Procedure "A").


i.

Idle the engine for at least 1 minute under the following conditions (Procedure "B"):

·

The water temperature is 60°C (140°F) or more.

·

The fuel temperature is 20°C (68°F) or more.


NOTICE:

Do not race the engine immediately after starting the engine. After warming up the engine, racing the engine is acceptable.


HINT:

If the temperature is difficult to estimate, use the intelligent tester and enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp and Fuel Temperature.



j.

Initialization is complete.



DIESEL THROTTLE BODY INITIALIZATION PROCEDURE


NOTICE:
·

After replacing the diesel throttle body assembly and/or the ECM, perform the Diesel Throttle Body Initialization.

·

When disconnecting the negative (-) battery cable, perform the Diesel Throttle Body Initialization after the terminal is reconnected.



a.

Turn the ignition switch to ON (Procedure "A").


b.

Turn the ignition switch off (Procedure "B").


c.

Repeat procedures "A" and "B" described above 2 times.