CHECK DTC AND FREEZE FRAME DATA
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.
DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display the current and pending DTCs.
Some DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check and make a note of the DTCs and freeze frame data.
Confirm the details of the DTCs (Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC AND FREEZE FRAME DATA
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON (do not start the engine).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
Erase the DTCs and freeze frame data by pressing YES on the tester.
When DTC P0095, P0096, P0097, P0098, P0100, P0101, P0102, P0103, P0105, P0106, P0107, P0108, P0405, P0406, P2BAB or P2BAC is detected, the DTC cannot be cleared using the intelligent tester.
CLEAR DTCS AND FREEZE FRAME DATA (not using the intelligent tester)
Remove the EFI-MAIN fuse from the fuse block for more than 60 seconds, or disconnect the cable from the negative battery terminal for more than 60 seconds.