Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM C

N04C-UH ENGINE CONTROL  ECD SYSTEM  P0116  Engine Coolant Temperature Circuit Range / Performance Problem  


DESCRIPTION

A thermistor is built into the Engine Coolant Temperature (ECT) sensor and it changes its resistance value according to the engine coolant temperature.

The structure of the sensor and connection to the ECM are the same as the intake air temperature sensor.

DTC No. DTC Detection Condition Trouble Area
P0116 If the engine coolant temperature was between -40°C (-40°F) and 60°C (140°F) at engine start, and conditions (a) and (b) are met:
(2 trip detection logic)
(a) Vehicle is driven at varying speeds (accelerating and decelerating)
(b) Engine coolant temperature remains within 3°C (5.4°F) of the engine starting temperature
·

Engine coolant temperature sensor

·

Thermostat


If the engine coolant temperature was more than 60°C (140°F) at engine start, and conditions (a) and (b) are met:
(2 trip detection logic)
(a) Vehicle is driven at varying speeds (accelerating and decelerating)
b) Engine coolant temperature remains within 1°C (1.8°F) of the engine starting temperature.

CAUTION / NOTICE / HINT

HINT:
·

If DTCs P0115, P0116, P0117, and P0118 are output simultaneously, the engine coolant temperature sensor circuit may be open or shorted. Perform troubleshooting for those DTCs first.

·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.


Result:
Result Proceed to
P0116 A
P0116 and other DTCs B



A

2.INSPECT THERMOSTAT

B

2.INSPECT THERMOSTAT
a.

b.

Check the valve opening temperature of the thermostat (Click hereEngine / Hybrid System>N04C-UH (COOLING)>THERMOSTAT>INSPECTION).

Standard:

80 to 84°C (176 to 183°F)



c.

Result:
Proceed to
OK
NG



OK

NG