Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM C

N04C-UH ENGINE CONTROL  ECD SYSTEM  P0168  Fuel Temperature Too High  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
P0168 After engine is warmed up, conditions (a) and (b) continue for more than 1 second:
(1 trip detection logic)
(a) Engine speed: 1000 rpm or more
(b) Fuel temperature (at injector): 151°C (304°F) or more
Fuel cooler

CAUTION / NOTICE / HINT

HINT:
·

If the engine is operated under high load when the fuel level is low, this DTC may be stored. If the DTC is stored, first check the fuel level.

·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0168)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.

Result:
Result Proceed to
DTC P0168 A
DTC P0168 and other DTCs B


HINT:

If any DTCs other than P0168 are output, troubleshoot those DTCs first.




A

B