78100
1.INSPECT ACCELERATOR PEDAL ASSEMBLY
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
While the accelerator pedal is depressed and released, check that the values of Accel Sensor Out No. 1 and Accel Sensor Out No. 2 are within the specifications.
| Condition | Accel Sensor Out No. 1 | Accel Sensor Out No. 2 |
|---|---|---|
| Accelerator pedal released | 0.6 to 1.0 V | 1.4 to 1.8 V |
| Accelerator pedal depressed | 2.8 to 3.6 V | 3.6 to 4.4 V |
If the results are not as specified, check the accelerator pedal, wire harness and ECM.