Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355865 AUTOMATIC TRANSMISSION SYSTEM D

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  HYDRAULIC TEST  


MEASURE LINE PRESSURE


C174715E02
0.688,1.688 0.688,1.385 true 2.271,1.021 2.729,0.198 2.729,0.198 2.875,0.198 true 2.927,0.135 3.385,0.333 0.458,0.198 10 false SST 0.521,1.719 0.927,1.917 0.406,0.198 10 true SST

NOTICE:
·

Perform the test at the normal operating ATF temperature: 50 to 80°C (122 to 176°F).

·

The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.

·

Be careful to prevent SST's hose from interfering with the exhaust pipe.

·

This test must be performed after checking and adjusting the engine.

·

Perform the test with the A/C OFF.



a.

Warm up the ATF.


b.

Remove the test plug from the front side of the transmission case and connect SST.

SST
09992-00095  (09992-00231, 09992-00271)


c.

Fully apply the parking brake and chock the 4 wheels.


d.

Start the engine and check idling speed.


e.

Keep your left foot firmly on the brake pedal and move the shift lever to D.


f.

Measure the line pressure when the engine is idling.


g.

Depress the accelerator pedal as much as possible. Quickly read the highest line pressure reading when the engine speed reaches stall speed.


h.

Perform the measure line pressure test again with the shift lever on R.

Specified line pressure:
Condition Shift Lever on D Shift Lever on R
Idling 652 to 750 kPa
(7 to 8 kgf/cm2, 95 to 109psi)
1,213 to 1,409 kPa
(12 to 14kgf/cm2, 176 to 204psi)
Stall 1,105 to 1,281 kPa
(11 to 13 kgf/cm2, 160 to 186 psi)
1,572 to 1,827 kPa
(16 to 19 kgf/cm2, 228 to 265 psi)

Evaluation:
Problem Possible Cause
Measured values at all positions are higher than specified
·

Shift solenoid valve SLT defective

·

Regulator valve defective


Measured values at all positions are lower than specified
·

Shift solenoid valve SLT defective

·

Regulator valve defective

·

Oil pump defective

·

O/D direct clutch defective


Pressure is low when shift lever is on D only
·

D position circuit fluid leak

·

Forward clutch defective


Pressure is low when shift lever is on R only
·

R position circuit fluid leak

·

Direct clutch defective

·

1st and reverse brake defective