The shift solenoid valve SL is turned ON and OFF by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| 64 | TCM detects open or short in shift solenoid valve SL circuit (once) when shift solenoid valve SL is operated (1 trip detection logic) | ·
Open or short in shift solenoid valve SL circuit ·
Shift solenoid valve SL ·
Transmission wire ·
TCM |
Fail-safe function:
If the TCM detects a malfunction, it turns the shift solenoid valve SL OFF.
Torque converter lock-up is controlled by the TCM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift position selection. When conditions are appropriate, the TCM requests "lock-up" by applying control voltage to the shift solenoid valve SL. When the shift solenoid valve SL is opened, the shift solenoid valve SL applies pressure to the lock-up relay valve and locks the torque converter clutch. If the TCM detects an open or short in the shift solenoid valve SL circuit, the TCM interprets this as a fault in the shift solenoid valve SL or its circuit. The TCM will store the DTC.
Disconnect the transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Component without harness connected:
(Transmission Wire) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B78-24 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
| *1 | Rear view of wire harness connector:
(to TCM) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the shift solenoid valve SL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - Solenoid body | 20°C (68°F) | 11 to 15 Ω |
| *1 | Shift solenoid valve (SL) |
Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
Check the operating noise of the solenoid valve.
The solenoid makes an operating sound.
| Proceed to |
|---|
| OK |
| NG |
OK
NG