Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › OIL PUMP › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355877 OIL PUMP G

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  INSPECTION  


PROCEDURE

Hide 35301 1.INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY

a.
Q002781

Using a dial indicator, measure the inside diameter of the oil pump body bushing.

Standard inside diameter:

42.05 to 42.075 mm (1.6565 to 1.6587 in.)


Limit inside diameter:

42.13 mm (1.6587 in.)


NOTICE:

If the inside diameter is greater than the standard inside diameter, replace the oil pump body.



Hide 35308 2.INSPECT FRONT OIL PUMP COVER SUB-ASSEMBLY

a.
Q002783

Using a dial indicator, measure the inside diameter of the front oil pump cover bushing.

Standard inside diameter:

Front side 24.000 to 24.021 mm (0.9449 to 0.9457 in.)

Rear side 26.500 to 26.521 mm (1.0433 to 1.0441 in.)


Limit inside diameter:

Front side 24.07 mm (0.9476 in.)

Rear side 26.57 mm (1.0461 in.)


NOTICE:

If the inside diameter is greater than the standard inside diameter, replace the front oil pump cover sub-assembly.



Hide 3.INSPECT CLEARANCE OF OIL PUMP ASSEMBLY

a.
Q002777

Push the driven gear to one side of the body.

Standard body clearance:

0.07 to 0.15 mm (0.0028 to 0.0059 in.)


Limit body clearance:

0.30 mm (0.0118 in.)



b.

Using a thickness gauge, measure the clearance.


c.
Q002778

Using a thickness gauge, measure the clearance between the driven gear teeth and the drive gear teeth.

Standard tip clearance:

0.14 to 0.24 mm (0.0055 to 0.0094 in.)


Limit tip clearance:

0.30 mm (0.0118 in.)



d.
Q002779

Using a steel straight edge and thickness gauge, measure the side clearance of both gears.

Standard side clearance:

0.02 to 0.05 mm (0.0008 to 0.0020 in.)


NOTICE:

If the side clearance is greater than the standard thickness, check the drive gear, the driven gear and the pump body.


HINT:

There are 5 different thicknesses for the drive and driven gears.

Variety of drive and driven gears
Drive gear Driven gear thickness
35321-60040 35322-60040 13.948 to 13.962 mm (0.5491 to 0.5497 in.)
35321-60050 35322-60050 13.963 to 13.977 mm (0.5497 to 0.5503 in.)
35321-60060 35322-60060 13.978 to 13.992 mm (0.5503 to 0.5509 in.)
35321-60070 35322-60070 13.993 to 14.007 mm (0.5509 to 0.5515 in.)
35321-60080 35322-60080 14.008 to 14.022 mm (0.5515 to 0.5520 in.)



Hide 4.INSPECT OIL PUMP DRIVE GEAR ROTATION

a.
Q002774

Make sure that the drive gear rotates smoothly.


b.

Remove the oil pump assembly from the torque converter.