35633
1.INSPECT FRONT CLUTCH CLUTCH DISC
Check whether the sliding surfaces of the 7clutch discs, the 7 clutch plates, are worn or burnt.
If the linings of the discs are peeled off or discolored, or if any part of the printed numbers is damaged, replace all discs.
35602
2.INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY
Check that the check ball is free by shaking the piston.
Check that the valve does not have leaks by applying low-pressure compressed air.
3.INSPECT PISTON STROKE OF FRONT CLUTCH
Install the SST to the dial indicator, and then set them to the front clutch piston vertically.
Do not let the SST touch except the piston.
Install the rear clutch hub.
Using a screwdriver, install the rear clutch hub hole snap ring.
Do not install the front clutch hub.
Make sure the front clutch piston moves smoothly when applying compressed air to the oil hole of the overdrive support assembly.
3.93 to 4.23 mm (0.1547 to 0.1665 in.)
Measure it at several positions and take the average. If the piston stroke is still outside the standard even after reassembling, select another clutch plate.
| Clutch plate | thickness |
|---|---|
| 35634-36010 | 1.75 to 1.85 mm (0.0689 to 0.0728 in.) |
| 35634-36040 | 1.95 to 2.05 mm (0.0768 to 0.0807 in.) |
| 35634-36050 | 2.15 to 2.25 mm (0.0846 to 0.0886 in.) |
| 35634-36020 | 2.35 to 2.45 mm (0.0925 to 0.0965 in.) |
Using a screwdriver, removed the rear clutch hub hole snap ring.
Remove the rear clutch hub.