Home › Drivetrain › A444E (AUTOMATIC TRANSMISSION / TRANSAXLE) › REAR CLUTCH ASSEMBLY › 2017.01–2021.01
RM2850E _52 Drivetrain _073139 A444E AUTOMATIC TRANSMISSION / TRANSAXLE _0355884 REAR CLUTCH ASSEMBLY G

A444E AUTOMATIC TRANSMISSION / TRANSAXLE  REAR CLUTCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 35673 1.INSPECT REAR CLUTCH DISC

a.
Q000491

Check whether the sliding surfaces of the 5 rear clutch discs, the 5 rear clutch plates, and the flange are worn or burnt.

NOTICE:

If the linings of the discs are peeled off or discolored, or if any part of the printed numbers is damaged, replace all discs.



Hide 35606 2.INSPECT REAR CLUTCH PISTON SUB-ASSEMBLY

a.
Q000470

Check that the check ball is free by shaking the piston.


b.

Check that the valve does not have leaks by applying low-pressure compressed air.


Hide 3.INSPECT PISTON STROKE OF REAR CLUTCH

a.
Q002864

Install the rear clutch assembly to the center support assembly as show in the illustration.


b.

Install the SST to the dial indicator, and then set them to the rear clutch piston vertically.

SST
09350-36010  (09350-06110)

NOTICE:

Do not let the SST touch except the piston.



c.

Make sure the piston moves smoothly when applying compressed air to the oil hole of the center support assembly.

Standard:

2.00 to 2.20 mm (0.0787 to 0.0866 in.)


NOTICE:

Measure it at several positions and take the average. If the piston stroke is still outside the standard even after reassembling, select another clutch flange.


HINT:
Clutch flange Mark thickness
35675-60010 A 5.0 mm (0.1969 in.)
35675-60020 B 5.2 mm (0.2047 in.)
35675-60050 E 4.6 mm (0.1811 in.)
35675-60060 F 4.8 mm (0.1890 in.)