84640C
1.REMOVE EXHAUST RETARDER SWITCH ASSEMBLY
w/ Exhaust Brake:
Disconnect the connector and detach the clamp.
Remove the lock nut and exhaust retarder switch assembly from the pedal bracket sub-assembly.
2.REMOVE CLUTCH PEDAL STOPPER BOLT
w/o Exhaust Brake:
Remove the lock nut and clutch pedal stopper bolt from the pedal bracket sub-assembly.
31301R
3.REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING
While the clutch pedal is fully depressed, remove the turn over spring seat compression spring.
31301P
4.REMOVE CLUTCH PEDAL TURNOVER BUSH
Remove the clutch pedal turnover bush from the clutch pedal sub-assembly.
31453A
5.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
Remove the clip and clutch master cylinder push rod clevis with hole pin.
31301
6.REMOVE CLUTCH PEDAL SUB-ASSEMBLY
Remove the nut, spring washer, bolt and clutch pedal sub-assembly from the pedal bracket subassembly.
31353
7.REMOVE CLUTCH PEDAL SPRING HOLDER
Using a screwdriver, remove the E-ring, and then remove the clutch pedal spring holder, clutch pedal spring and clutch pedal bush from the clutch pedal support sub-assembly.
| *1 | E-ring |
| *2 | Clutch Pedal Spring Holder |
| *3 | Clutch Pedal Spring |
| *4 | Clutch Pedal Bush |
| *5 | Clutch Pedal Support Sub-assembly |
31301C
8.REMOVE CLUTCH PEDAL BUSH
Remove the 2 clutch pedal bushes and clutch pedal shaft collar from the clutch pedal sub-assembly.
| *1 | Clutch Pedal Shaft Collar |
| *2 | Clutch Pedal Bush |
31301B
9.REMOVE NO. 1 CLUTCH PEDAL CUSHION
Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
31453B
10.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
Using a socket hexagon wrench (8 mm) and plastic faced hammer, remove the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.
31321
11.REMOVE CLUTCH PEDAL PAD
Remove the clutch pedal pad from the clutch pedal sub-assembly.