Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER
RM2850E _52 Drivetrain _073140 CLUTCH _0355887 CLUTCH MASTER CYLINDER A

CLUTCH  CLUTCH MASTER CYLINDER  DISASSEMBLY  


PROCEDURE

Hide 04311 1.REMOVE CLUTCH MASTER CYLINDER KIT

a.

w/o Clutch Booster:

i.
C087881

Using a vernier caliper, measure the length (A) of the threaded portion on the push rod.


ii.
C367382

Secure the cylinder body between aluminum plates in a vise, loosen the lock nut and remove the push rod clevis from the push rod.

NOTICE:

Applying force to the cylinder body may cause it to deform. Do not grasp the cylinder body in a vise.



iii.

Remove the lock nut from the push rod.


iv.

Remove the boot from the cylinder body.


v.
C367383

While pushing the push rod, using snap ring pliers, remove the snap ring.


vi.

Remove the push rod from the cylinder body.

NOTICE:

The piston may pop up out of the cylinder body. Therefore, slowly remove the push rod from the cylinder body.



vii.

Remove the stop plate from the push rod.


viii.

Remove the piston straight from the cylinder body.

NOTICE:

Be careful not to damage the inside of the cylinder body.




b.

w/ Clutch Booster:

i.
C367379

Secure the cylinder body between aluminum plates in a vise and use snap ring pliers to remove the snap ring.

NOTICE:

Applying force to the cylinder body may cause it to deform. Do not grasp the cylinder body in a vise.



ii.

Remove the piston straight from the cylinder body.

NOTICE:

Be careful not to damage the inside of the cylinder body.