31470
1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
Install the clutch release cylinder assembly with the 2 bolts.
12 N*m (120 kgf*cm, 9 ft.*lbf)
31482
2.CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench (12 mm), connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.
24 N*m (245 kgf*cm, 18 ft.*lbf)
| *a | Torque Wrench Fulcrum Length |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 22 N*m (220 kgf*cm, 16 ft.*lbf)
3.CHECK FOR CLUTCH FLUID LEAKAGE
4.BLEED AIR FROM CLUTCH PIPE LINE
Connect the vinyl tube to the release cylinder bleeder plug.
Depress the clutch pedal several times and loosen the release cylinder bleeder plug with the clutch pedal depressed.
At the point where the brake fluid stops coming out, tighten the release cylinder bleeder plug and release the clutch pedal.
Repeat until no air remains in the brake fluid.
11 N*m (110 kgf*cm, 8 ft.*lbf)
5.CHECK FLUID LEVEL IN RESERVOIR