Home › Drivetrain › CLUTCH › CLUTCH UNIT (for M551)
RM2850E _52 Drivetrain _073140 CLUTCH _0355891 CLUTCH UNIT(for M551) G

CLUTCH  CLUTCH UNIT(for M551)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

a.
C103826

Using vernier calipers, measure the rivet head depth.

Minimum Rivet Depth:

0.3 mm (0.012 in.)


If necessary, replace the clutch disc assembly.


b.

Install the clutch disc assembly onto the transmission.

NOTICE:

Insert the clutch disc assembly in the correct orientation.



c.
C152798E01
1.544,3.206 2.793,3.371 1.249,0.166 10 Transmission Side 1.539,3.308 1.295,3.308 false

Using a dial indicator, check the clutch disc assembly runout.

Maximum Runout:

0.8 mm (0.032 in.)


If necessary, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

a.
C147953E01
0.423,0.503 0.556,0.664 0.133,0.161 10 A 1.15,0.228 1.295,0.405 0.145,0.177 10 B

Using vernier calipers, inspect the depth and width of wear of the diaphragm spring.

Maximum:
A (Depth):

0.6 mm (0.024 in.)

B (Width):

5.0 mm (0.197 in.)


If necessary, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

a.
C103832

Using a dial indicator, inspect the flywheel sub-assembly runout.

Maximum Runout:

0.1 mm (0.004 in.)


If necessary, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
N000414

Turn the release bearing by hand while applying force in the axial direction.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.

If necessary, replace the release bearing assembly.