1.INSPECT V BELT
Check the V belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V belt.
The V belt is cracked.
The V belt is worn out to the extent that the cords are exposed.
The V belt has chunks missing from the ribs.
Check that the V belt fits properly in the ribbed grooves.
Check with your hand to confirm that the V belt has not slipped out of the groove on the bottom of the pulley. If it has slipped out, replace the V belt. Install the V belt correctly.
Check the fan and generator V belt deflection.
The specified deflection and tension values per belt are shown in the following table.
| Item | Specified Condition |
|---|---|
| New belt | 10.5 to 12.5 mm (0.413 to 0.492 in.) |
| Used belt | 12 to 13 mm (0.472 to 0.512 in.) |
| Item | Specified Condition |
|---|---|
| New belt | 350 to 500 N (36 to 51 kgf, 79 to 112 lbf) |
| Used belt | 300 to 400 N (31 to 41 kgf, 67 to 90 lbf) |
Make sure not to tighten the fan and generator V belt higher than the specified tension. When the fan and generator V belt is overtightened, the lifespan of the fan and generator V belt is reduced.
If the fan and generator V belt deflection amount is 15 mm or more (tension 150 N (15 kgf, 34 lbf)), the fan and generator V belt may slip. Therefore, readjust the fan and generator V belt to the tension specified for "Used belt". (Frequent readjustment of the fan and generator V belt reduces the lifespan of the fan and generator V belt.)
Check that there are no cracks and damage on the fan and generator V belt. If there are any abnormalities, replace the part.
The fan and generator V belt tension decreases after the vehicle has been driven, but since this occurs during the initial break-in period, this is not a malfunction.
Check the No. 1 V (cooler compressor to crankshaft pulley) belt deflection and tension.
The specified deflection and tension valves per belt are shown in the following table.
| Item | Specified Condition |
|---|---|
| New belt | 8.6 to 10.6 mm (0.339 to 0.417 in.) |
| Used belt | 10.7 to 12.1 mm (0.421 to 0.476 in.) |
| Item | Specified Condition |
|---|---|
| New belt | 404 to 576 N (41 to 59 kg, 91 to 129 lbf) |
| Used belt | 294 to 392 N (30 to 40 kg, 66 to 88 lbf) |
Check the V belt deflection at the specified point.
When installing a new belt, set its tension to the specified value.
When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.