1.INSTALL STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.
Using E8 and E10 "TORX" socket wrenches, install the stud bolts.
| *a | Intake Manifold Side | *b | Exhaust Manifold Side |
| *c | 32.5 mm (1.28 in.) | *d | 18.0 mm (0.708 in.) |
| *e | 10.5 mm (0.413 in.) | *f | 52.5 mm (2.07 in.) |
| *g | 19.5 mm (0.767 in.) | *h | 12.0 mm (0.472 in.) |
| *i | 63.5 mm (2.50 in.) | - | - |
13715A
2.INSTALL EXHAUST VALVE STEM OIL SEAL
Apply a light coat of engine oil to the valve guide bush.
Using SST, install a new exhaust valve stem oil seal.
29.0 to 29.5 mm (1.14 to 1.16 in.)
| *a | Height |
After pressing in the exhaust valve stem oil seal, check that the height of the exhaust valve stem oil seal is as illustrated.
13711E
3.INSTALL INTAKE VALVE STEM OIL SEAL
Apply a light coat of engine oil to the valve guide bush.
Using SST, install a new intake valve stem oil seal.
29.0 to 29.5 mm (1.14 to 1.16 in.)
| *a | Height |
After pressing in the intake valve stem oil seal, check that the height of the intake valve stem oil seal is as illustrated.
13711
4.INSTALL INTAKE VALVE
Apply engine oil to the intake valve tip.
Install the intake valve, inner compression spring and valve spring retainer.
Install the parts to their original locations.
Using SST, compress the inner compression spring and place the 2 valve spring retainer locks around the valve stem.
Using a 5 mm pin punch, lightly tap the valve stem tip to ensure a proper fit.
Be careful not to damage the valve stem tip.
13715
5.INSTALL EXHAUST VALVE
Apply engine oil to the exhaust valve tip.
Install the exhaust valve, inner compression spring and valve spring retainer.
Install the parts to their original locations.
Using SST, compress the inner compression spring and place the 2 valve spring retainer locks around the valve stem.
Using a 5 mm pin punch, lightly tap the valve stem tip to ensure a proper fit.
Be careful not to damage the valve stem tip.