Home › Engine / Hybrid System › N04C-VQ (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM2850E _51 Engine / Hybrid System _073144 N04C-VQ ENGINE MECHANICAL _0355912 REAR CRANKSHAFT OIL SEAL A

N04C-VQ ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR ENGINE OIL SEAL

a.

Apply MP grease to the rear engine oil seal lip.


b.
A265613E02
1.385,0.938 1.604,0.146 1.604,0.146 1.75,0.146 false 1.792,0.052 2.208,0.219 0.417,0.167 10 false SST 2.729,0.271 2.958,0.438 0.229,0.167 10 false *a

Using SST and a hammer, tap in a new rear engine oil seal until it is 4 mm (0.157 in.) below the upper edge of the flywheel housing.

SST
09223-78010  

Text in Illustration
*a 4 mm (0.157 in.)

NOTICE:
·

Be careful not to tap the rear engine oil seal at an angle.

·

Keep the gap between the rear oil seal retainer edge and the rear engine oil seal free of foreign matter.




Hide 31250 3.INSTALL CLUTCH DISC ASSEMBLY

Hide 31210 4.INSTALL CLUTCH COVER ASSEMBLY

Hide 31210 5.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

Hide 33110 6.INSTALL MANUAL TRANSMISSION ASSEMBLY