1.INSTALL FUEL TANK CUSHION
Install 9 new fuel tank cushions.
77011
2.INSTALL LOWER FUEL TANK FILLER PIPE SUB-ASSEMBLY
Install a new gasket and the lower fuel tank filler pipe sub-assembly with the 8 screws.
3.0 N*m (31 kgf*cm, 27 ft.*lbf)
3.INSTALL BREATHER TUBE FUEL HOSE
Install the breather tube fuel hose onto the lower fuel tank filler pipe and tighten the clamp.
| *a | Upper |
77213B
4.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose onto the lower fuel tank filler pipe and tighten the clamp.
| *a | Upper |
77420
5.INSTALL NO. 2 FUEL CUT OFF VALVE ASSEMBLY
Install the No. 2 fuel cut off valve onto the fuel tank.
77380
6.INSTALL FUEL CUT OFF VALVE ASSEMBLY
Install the fuel cut off valve onto the fuel tank.
77026A
7.INSTALL NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Install 2 new gaskets and the No. 1 fuel evaporation tube with the 8 screws and nut.
1.5 N*m (15 kgf*cm, 13 in.*lbf) for screw
3.0 N*m (31 kgf*cm, 27 in.*lbf) for nut
77017B
8.INSTALL FUEL TANK VENT TUBE SUB-ASSEMBLY
Install the grommet onto the fuel tank.
Install a new gasket and the fuel tank vent tube with the 6 screws.
3.0 N*m (31 kgf*cm, 27 in.*lbf)
83320
9.INSTALL FUEL SENDER GAUGE ASSEMBLY
Install the fuel sender gauge assembly with the 5 screws.
1.5 N*m (15 kgf*cm, 13 in.*lbf)
77100
10.INSTALL FUEL TANK ASSEMBLY
Set the fuel tank on an engine lifter.
Raise the engine lifter.
Connect the 2 fuel tank bands with the 2 bolts.
45 N*m (459 kgf*cm, 33 ft.*lbf)
11.CONNECT BREATHER TUBE FUEL HOSE
Connect the breather tube fuel hose and tighten the clamp.
| *a | Upper |
12.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the fuel tank to filler pipe hose and tighten the clamp.
| *a | Upper |
13.CONNECT FUEL CHECK VALVE HOSE
Connect the fuel check valve hose with the clamp.
14.CONNECT FUEL RETURN HOSE
Connect the fuel return hose with the clamp.
15.CONNECT FUEL MAIN HOSE
Connect the fuel main hose with the clamp.
58750
16.INSTALL FUEL TANK INSPECTION HOLE COVER ASSEMBLY
Connect the sender gauge connector.
Install the fuel tank inspection hole cover assembly with the 2 screws.
17.BLEED AIR FROM FUEL SYSTEM
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19.INSPECT FOR FUEL LEAK