In a malfunction where the EGR system is always on, black or white smoke may emit from the exhaust pipe.
1.CHECK SEATING OF EGR VALVE
Start the engine. Check that the engine starts and then idles.
2.INSPECT FOR EGR VALVE ASSEMBLY
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the EGR Step Position.
Read the Data List "Target EGR Position" and "Actual EGR Valve Pos." values during the Active Test.
The Actual EGR Valve Pos. value follows the Target EGR Position value.
If the result is not as specified, refer to DTC P1458 or P1459.
3.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
Detachment or other problems with the engine oil dipstick, filler cap, PCV hose and other components may cause the engine to run improperly.
Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunction.
If any defects are found, replace parts as necessary.