Home › Engine / Hybrid System › N04C-VQ (COOLING) › RADIATOR
RM2850E _51 Engine / Hybrid System _073147 N04C-VQ COOLING _0355932 RADIATOR G

N04C-VQ COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT RADIATOR CAP SUB-ASSEMBLY

A138101

a.

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the parts with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that rubber packings 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.
Z000570E12
1.719,0.917 1.917,0.323 1.917,0.323 2.073,0.323 true 0.406,0.979 0.406,1.5 true 2.104,0.229 2.417,0.427 0.313,0.198 10 false *a 0.313,1.521 0.625,1.719 0.313,0.198 10 false *1 1.438,1.063 1.625,1.25 0.188,0.188 10 true *b

When using the cap tester, tilt it to more than 30 degrees.

Text in Illustration
*1 Radiator Reservoir Cap
*a Radiator Cap Tester
*b More than 30°


vi.

Pump the cap tester several times, and check the maximum pressure*1.

Pumping speed:

1 pump per second.


*1: Even if the cap cannot maintain the maximum pressure it is not a defect.

Judgement Criteria:
Item Specified Condition

If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.

Standard value (for brand new cap) 93 to 123 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (after using cap) 78 kPa (0.8 kgf/cm2, 11.4 psi)