28011
1.INSTALL STARTER CLUTCH SUB-ASSEMBLY
Apply high temperature grease to the parts indicated by arrow marks in the illustration.
|
High Temperature Grease |
Install the starter clutch sub-assembly into the magnet starter switch assembly.
Make sure that the bearing does not disengage from the clutch.
Install the 3 starter washers and pinion drive lever with the snap ring.
28110
2.INSTALL STARTER DRIVE HOUSING ASSEMBLY
Apply a light coat of seal packing to the surface of the starter drive housing assembly that contacts the magnet starter switch assembly.
Three Bond 1121 or equivalent
| *1 | Starter Drive Housing Assembly |
| *a | Seal Packing |
Install the starter drive housing assembly with the 2 bolts.
28256
3.INSTALL STARTER INTERNAL GEAR
Apply high temperature grease to the portion indicated by the arrow in the illustration.
|
High Temperature Grease |
Install the starter internal gear.
Make sure the starter internal gear protrusion indicated by the arrow in the illustration is aligned with the groove on the bottom side of the magnet starter switch assembly.
Apply high temperature grease to the 3 starter planetary gears.
| *1 | Starter Planetary Gears |
Install the 3 starter planetary gears.
28160
4.INSTALL STARTER ARMATURE ASSEMBLY
Install the starter washer.
Make sure that the starter washer is securely seated in the groove.
Apply high temperature grease to the portion indicated by the arrow in the illustration.
|
High Temperature Grease |
Install the starter plate.
Apply high temperature grease to the portion indicated by the arrow in the illustration.
|
High Temperature Grease |
Install the starter armature assembly to the magnet starter switch assembly.
28120
5.INSTALL STARTER YOKE ASSEMBLY
Install 2 new rubber seals to the starter yoke assembly.
Install the terminal to the terminal C.
| *a | Terminal |
| *b | Terminal C |
Install the starter yoke assembly to the magnet starter switch assembly.
28140
6.INSTALL STARTER BRUSH HOLDER ASSEMBLY
Place the starter brush holder assembly on the starter armature assembly.
Using a screwdriver, hold the starter brush spring back and connect the 4 starter brushes to the starter brush holder assembly.
Check that the positive(+) lead wires are not grounded.
| *a | Starter Brush Spring |
| *b | Starter Brush |
Install the starter brush holder assembly into the starter armature assembly.
Apply high temperature grease to the portion indicated by the arrow in the illustration.
|
High Temperature Grease |
Install the commutator end frame with the 2 screws.
3.9 N*m (40 kgf*cm, 35 ft.*lbf)
Install the 2 through bolts.
17 N*m (168 kgf*cm, 12 ft.*lbf)
Install the nut to terminal C.
21 N*m (214 kgf*cm, 15 ft.*lbf)
| *a | Terminal C |
Install the dust protector to commutator end frame.
28213
7.INSTALL STARTER CLUTCH PINION
Using a snap ring pliers, Install the starter drive spring, starter clutch pinion and pinion stop nut with a new retainer.