Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › ENGINE
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355944 ENGINE A

1HZ ENGINE MECHANICAL  ENGINE  INJECTION TIMING INSPECTION AND ADJUSTMENT  


PROCEDURE

Hide 1.INSTALL SST AND DIAL INDICATOR

a.
A422734

Remove the plug bolt and gasket from the distributive head plug of the injection pump.


b.

Install SST (plunger stroke measuring tool) and a dial indicator to the plug bolt hole of distributive head plug.

SST
09275-54011  


Hide 2.RELEASE ACSD ADVANCE (w/ ACSD)

a.

Using a screwdriver, turn the cold starting lever counterclockwise approx. 20°.


b.
A422735

Put a metal plate (thickness of 8 - 10 mm (0.315 - 0.394 in.) between the cold starting lever and thermowax plunger.


Hide 3.SET NO.1 OR NO.6 CYLINDER TO TDC/COMPRESSION

a.
A422736

Turn the crankshaft pulley clockwise, and align its groove with the timing gear cover groove.


Hide 4.ADJUST INJECTION TIMING

a.
A422737

Slowly rotate the crankshaft pulley counterclockwise and set the dial indicator at 0 mm (0 in.) when the dial indicator reaches the minimum value.

NOTICE:

Compared with previous 4 cylinder engines the 0 mm (0 in.) position (crank angle) is reduced, so perfrom the operation carefully.



b.
A422738

Turn the crankshaft to the left and right and check that the dial indicator shows the minimum value.


c.

Slowly rotate the crankshaft pulley clockwise until pulley groove is aligned with timing gear cover groove.


d.
A422739

Measure the plunger stroke.

Plunger stroke:

1.03 - 1.09 mm (0.0406 - 0.0429 in.)



e.

Repeat steps (a) to (d) several times.


f.
A422740

Loosen these nuts and bolt:

i.

6 union nuts of injection pipes at injection pump side


ii.
A422741

Bolt holoing injection pump to injection pump stay


iii.
A422742

2 nuts holding injection pump to timing gear case



g.
A422743

Adjust plunger stroke by slightly tilting the injection pump body.

If the stroke is less than specification, tilt the pump toward the engine.

If the stroke is greater than specification, tilt the pump away from the engine.


h.
A422744

Tighten these nuts and bolt:

i.

2 nuts holding injection pump to timing gear case

Torque:

18 N*m (185 kgf*cm, 13 ft*lbf)



ii.
A422745

Bolt holding injection pump to injection pump stay

Torque:

69 N*m (700 kgf*cm, 61 ft*lbf)


Recheck the plunger stroke.



Hide 5.REMOVE MENTAL PLATE (w/ ACSD)

Hide 6.REMOVE SST AND DIAL INDICATOR

a.
A422746

Remove the SST and dial indicator.

SST
09275-54011  


b.

Install a new gasket and the plug bolt of the distributive head plug.

Torque:

17 N*m (170 kgf*cm, 12 ft*lbf)



Hide 7. TORQUE UNION NUTS OF INJECTION PIPES

A422747

Torque:

17 N*m (170 kgf*cm, 12 ft*lbf)


Hide 8. START ENGINE AND CHECK FOR LEAKAGE