1.INITIAL CONDITIONS
Engine at normal operating temperature
Air cleaner installed
All accessories switched OFF
All vacuum lines properly connected
Valve clearance set correctly
Injection timing set correctly
A/T:
Transmission in neutral position
M/T:
Steering wheel at straight-ahead position
Idle speed set correctly
M/T:
PS idle - up speed correctly
2.CONNECT TACHOMETER
3.ADJUST A/C IDLE-UP SPEED
Start the engine.
Turn the A/C switch ON, and set these position:
Blower switch to HI
Air intake control lever to RECIRCULATED AIR
Air flow control lever to FACE
Temperature control lever to COOL
Check the idle-up speed.
950 +/- 50 rpm
Loosen the lock nut, and adjust the idle-up setting speed by turning the idle-up speed adjusting screw.
Lock the adjusting screw with the lock nut.
Turn the A/C switch OFF, then ON again, and recheck the idle-up speed.
Turn the A/C switch OFF, and check that the rod end of the idle-up actuator is not touching the idle-up lever.