Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › TIMING GEARS
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355946 TIMING GEARS A

1HZ ENGINE MECHANICAL  TIMING GEARS  INJECTION PUMP DRIVE GEAR OIL SEAL REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are two methods (A and B) to replace the oil seal as follows:


PROCEDURE

Hide 1.REPLACE INJECTION PUMP DRIVE GEAR OIL SEAL

a.

If timing gear cover is removed from cylinder block:

i.
A422711

Using a screwdriver and hammer, tap out the oil seal.


ii.
A422712

Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

SST
09214-76011  


iii.

Apply MP grease to the oil seal lip.



b.

If timing gear cover is installed to the cylinder block:

i.
A422713

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the injection pump drive gear. Tape the screwdriver tip.



ii.
A422714

Apply MP grease to the oil seal lip.


iii.

Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

SST
09214-76011