Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › TIMING GEARS
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355946 TIMING GEARS A

1HZ ENGINE MECHANICAL  TIMING GEARS  CRANKSHAFT FRONT OIL SEAL REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are two methods (A and B) to replace the oil seal as follows:


PROCEDURE

Hide 1.REPLACE CRANKSHAFT FRONT OIL SEAL

a.

If timing gear cover is removed from cylinder block:

i.
A422707

Using a screwdriver and hammer, tap out the oil seal.


ii.
A422708

Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

SST
09223-78010  


iii.

Apply MP grease to the oil seal lip.



b.

If timing gear cover is installed to the cylinder block

i.
A422709

Using SST, remove the oil seal.

SST
09308-10010  


ii.
A422710

Apply MP grease to a new oil seal lip.


iii.

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

SST
09223-78010