Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER HEAD
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355947 CYLINDER HEAD A

1HZ ENGINE MECHANICAL  CYLINDER HEAD  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are two methods (A and B) to replace the oil seal as follows:


PROCEDURE

Hide 1.REPLACE CAMSHAFT OIL SEAL

a.
A422562

If camshaft oil seal retainer is removed from cylinder head:

i.

Using a screwdriver and hammer, tap out the oil seal.


ii.
A422563

Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil seal retainer edge.

SST
09223-46011  


iii.

Apply MP grease to the oil seal lip.



b.
A422564

If camshaft oil seal retainer is installed to the cylinder head:

i.

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the camshaft.

Tape the screwdriver tip.



ii.

Apply MP grease to a new oil seal lip.


iii.
A422565

Using SST and a hammer, tap in the oil seal until its surface is flush with the oil seal retainer edge.

SST
09223-46011