Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER BLOCK
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355948 CYLINDER BLOCK A

1HZ ENGINE MECHANICAL  CYLINDER BLOCK  PISTON AND CONNECTING ROD DISASSEMBLY  


PROCEDURE

Hide 1.CHECK FIT BETWEEN PISTON AND PISTON PIN

a.
A422415

Try to move the piston back and forth on the piston pin.

If any movement is felt, replace the piston and pin as a set.


Hide 2.REMOVE PISTON RINGS

a.
A422416

Using a piston ring expander, remove the two compression rings and oil ring.


b.
A422417

Remove the coil by hand.

HINT:

Arrange the rings in correct order only.



Hide 3.DISCONNECT CONNECTING ROD FROM PISTON

a.
A422418

Using a small screwdriver, remove the snap rings.


b.
A422419

Gradually heat the piston to approx. 80° C (176° F).


c.
A422420

Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

HINT:
A422421

·

The piston and pin are a matched set.

·

Arrange the pistons, pins, rings, connecting rods and bearings in correct order.