Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER BLOCK
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355948 CYLINDER BLOCK A

1HZ ENGINE MECHANICAL  CYLINDER BLOCK  PISTON AND CONNECTING ROD ASSEMBLY  


PROCEDURE

Hide 1.ASSEMBLE PISTON AND CONNECTING ROD

a.
A422454

Install a new snap ring on one side of the piston pin hole.

·

Position the snap ring so that end (B) of the snap ring is aligned with the hollow, then push the snap ring into the piston groove starting from end (A).



b.
A422455

Gradually heat the piston to about 80°C (176°F).


c.

Apply a light coat of engine oil to the piston pin.


d.
A422456

Align the front marks of the piston and connecting rod, and push in the piston pin with your thumb.


e.
A422457

Install a new snap ring on the other side of the piston pin hole using the same method as in (a) above.


Hide 2.INSTALL PISTON RINGS

a.
A422458

Install the coil by hand.


b.

Using a piston ring expander, install the oil ring.

HINT:
A422459

Face the end gap of the oil ring in the opposite direction of coil joint.



c.
A422460

Using a piston ring expander, install the two compression rings with the code mark facing upward.

Code mark:

No.1 1T

No.2 2T



d.
A422461

A422462

Position the piston rings so that the ring ends are as shown.

NOTICE:

Do not align the ring ends.



Hide 3.INSTALL BEARINGS

a.
A422463

Align the bearing claw with the claw groove of the connecting rod or connecting cap.


b.

Install the bearings in the connecting rod and connecting rod cap.