Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER BLOCK
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355948 CYLINDER BLOCK A

1HZ ENGINE MECHANICAL  CYLINDER BLOCK  CRANKSHAFT OIL SEAL REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are two methods (A and B) to replace the oil seal as follows:


PROCEDURE

Hide 1.REPLACE CRANKSHAFT REAR OIL SEAL

a.

If rear oil seal retainer is removed from cylinder block:

i.
A422450

Using a screwdriver and hammer, tap out the oil seal.


ii.
A422451

Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010  


iii.

Apply MP grease to the oil seal lip.



b.

If rear oil seal retainer is installed to cylinder block:

i.
A422452

Using a knife, cut off the oil seal lip.


ii.

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the crankshaft. Tape the screwdriver tip.



iii.
A422453

Apply MP grease to a new oil seal lip.


iv.

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010