Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › ENGINE TUNE-UP
RM2850E _51 Engine / Hybrid System _073150 1HZ ENGINE MECHANICAL _0355949 ENGINE TUNE-UP A

1HZ ENGINE MECHANICAL  ENGINE TUNE-UP  IDLE SPEED AND MAXIMUM SPEED ADJUSTMENT  


PROCEDURE

Hide 1.INITIAL CONDITION

a.

Engine at reach normal operating temperature


b.

Air cleaner installed


c.

All accessories switched OFF


d.

All vacuum lines properly connected


e.

Valve clearance set correctly


f.
A422643

Injection timing set correctly


g.

Transmission in N range


Hide 2.CONNECT TACHOMETER

Hide 3.ADJUST IDLE SPEED

a.

Check that the adjusting lever touches the idle speed adjusting screw when the accelerator pedal is released.

If not, adjust the accelerator linkage.


b.

Start the engine.


c.

Check the idle speed.

Idle speed:

1PZ: 600-700 rpm

1HZ M/T: 600-700 rpm

1HZ A/T: 660-760 rpm

1HD-T M/T: 600-700 rpm

1HD-T A/T: 750-850 rpm



d.

Adjust the idle speed.

·

Disconnect the accelerator linkage.

·
A422644

Loosen the lock nut of the idle speed adjusting screw.

·

Adjust the idle speed by turning the IDLE SPEED ADJUSTING SCREW.


Idle speed:

1PZ: 650 rpm

1HZ M/T: 650 rpm

1HZ A/T: 710 rpm

1HD-T M/T: 650 rpm

1HD-T A/T: 800 rpm


·

Securely tighten the lock nut, and recheck the idle speed.

·

Reconnect the accelerator linkage.

·
A422645

After adjustment, adjust the accelerator linkage.



Hide 4.ADJUST MAXIMUM SPEED

a.

Check that the adjusting lever touches the maximum speed adjusting screw when the accelerator pedal is depressed all the way.

If not, adjust the accelerator linkage.


b.

Start the engine.


c.

Depress the accelerator pedal all the way.


d.

Check the maximum speed.

Maximum speed:

1PZ and 1HZ: 4,500 - 4,700 rpm

1HD-T 4,300 - 4,500 rpm



e.

Adjust the maximum speed.

·

Disconnect the accelerator linkage.

·

Cut out the seal wire of the maximum speed adjusting screw.

·
A422645

(w/ HAC and 1HD-T)

Using SST, loosen the lock nut of the maximum speed adjusting screw.

·
A422646

(w/ HAC and 1HD-T)

Using SST, loosen the lock nut of the maximum speed adjusting screw.


SST
09275-54020  

·

(w/o HAC)

Loosen the lock nut of the maximum speed adjusting screw.

·
A422647

Adjust the maximum speed by turning the MAXIMUM SPEED ADJUSTING SCREW.


Maximum speed:

1PZ and 1HZ: 4,600 rpm

1HD-T 4,400 rpm


HINT:

Adjust at idle speed. Then, raise engine speed and recheck the maximum speed.


·

(w/ HAC and 1HD-T)

Using SST, securely tighten the lock nut.


SST
09275-54020  

·
A422648

(w/o HAC)

Securely tighten the lock nut.

·

Recheck the maximum speed.

·

Reconnect the accelerator linkage.

·

After adjustment, adjust the accelerator linkage.

·

Seal the maximum speed adjusting screw with a new seal wire.