Home › Engine / Hybrid System › 1HZ FUEL › INJECTION NOZZLES
RM2850E _51 Engine / Hybrid System _073151 1HZ FUEL _0355951 INJECTION NOZZLES A

1HZ FUEL  INJECTION NOZZLES  INJECTION NOZZLES CLEANING AND INSPECTION  


PROCEDURE

Hide 1. NOZZLE CLEANING

a.
A422778

To wash the nozzles. Use a wooden stick and brass brush. Wash them in clean diesel fuel.

HINT:

Do not touch the nozzle mating surfaces with your fingers.



b.
A422779

Using a wooden stick, remove the carbon adhering to the nozzle needle tip.


c.
A422780

Using a brass brush, remove the carbon from the exterior of the nozzle body (except lapped surface).


d.
A422781

Check the seat of the nozzle body for burns or corrosion.


e.

Check the nozzle needle tip for damage or corrosion.

If any of these conditions are present, replace the nozzle assembly.


Hide 2.INSPECT NOZZLE ASSEMBLY

a.
A422782

Wash the nozzle in clean diesel fuel.

HINT:

Do not touch the nozzle mating surfaces with your fingers.



b.

Tilt the nozzle body about 60 degrees and pull the needle out about one third of its length.


c.
A422783

When released, the needle should sink down into the body vent smoothly by its own weight.


d.

Repeat this test, rotating the needle slightly each time.

If the needle does not sink freely, replace the nozzle assembly.