Home › Engine / Hybrid System › 1HZ FUEL › FUEL HEATER SYSTEM
RM2850E _51 Engine / Hybrid System _073151 1HZ FUEL _0355953 FUEL HEATER SYSTEM A

1HZ FUEL  FUEL HEATER SYSTEM  COMPONENTS INSPECTION  


PROCEDURE

Hide 23910B 1.INSPECT FUEL HEATER

a.

Apply a vacuum of 350 +/- 50 mmHg (13.78 +/- 1.97 in.Hg, 46.7 +/- 6.7 kPa) or more to the vacuum switch port.


b.
A422753

Using an ohmmeter, measure the resistance between terminal 1 and the switch body.

Resistance:

0.5 - 2.0 Ω at 20° C (68° F)


If the resistance is not as specified, replace the fuel heater and vacuum switch assembly.


Hide 2.INSPECT SWITCH CONTINUITY (VACUUM SWITCH)

a.
A422754

Using an ohmmeter, check that there is no continuity between terminal 1 and the switch body.

If continuity is not as specified, replace the fuel heater and vacuum switch assembly.


Hide 3.INSPECT SWITCH OPERATION (VACUUM SWITCH)

a.
A422754

Apply a vacuum of 350 +/- 50 mmHg (13.78 +/- 1.97 in.Hg, 46.7 +/- 86.7 kPa) or more to the vacuum switch port.


b.
A422755

Using an ohmmeter, check that there is continuity between terminal 1 and the switch body.

If operation is not as specified, replace the fuel heater and vacuum switch assembly.


Hide 4.INSPECT RELAY CONTINUITY (FUEL HEATER RELAY (HZJ80 AND HDJ80 ONLY))

a.
A422756

LOCATION: In the engine compartment relay box.

i.
A422757

Using an ohmmeter, check that there is continuity between terminals 1 and 3.


ii.

Check that there is no continuity between terminals 2 and 4.

If continuity is not as specified, replace the relay.



Hide 5.INSPECT RELAY OPERATION (FUEL HEATER RELAY (HZJ80 AND HDJ80 ONLY))

a.
A422756

LOCATION: In the engine compartment relay box.

i.
A422758

Apply battery voltage across terminals 1 and 3.


ii.

Using an ohmmeter, check that there is continuity between terminals 2 and 4.

If operation is not as specified, replace the relay.