Home › Engine / Hybrid System › 1HZ FUEL › FUEL INJECTION PUMP
RM2850E _51 Engine / Hybrid System _073151 1HZ FUEL _0355954 FUEL INJECTION PUMP A

1HZ FUEL  FUEL INJECTION PUMP  INJECTION PUMP REMOVAL  


PROCEDURE

Hide 1. DRAIN COOLANT (w/ ACSD)

Hide 13523P 3.REMOVE NO.2 CAMSHAFT TIMING PULLEY

Hide 78104 4.DISCONNECT ACCELERATOR CONNECTING ROD

Hide 5.DISCONNECT THROTTLE CABLE (A/T)

Hide 6.DISCONNECT A/C IDLE-UP VACUUM HOSE (w/ A/C)

Hide 7.DISCONNECT WATER BY-PASS HOSES FROM THERMO WAX (w/ ACSD)

Hide 8.DISCONNECT INJECTION PUMP CONNECTOR

Hide 9.DISCONNECT FUEL HOSES FROM INJECTION PUMP

Hide 10.DISCONNECT BOOST COMPENSATOR HOSE (1HD-T)

Hide 11.DISCONNECT PCS VACUUM HOSE (w/PCS)

Hide 12.DISCONNECT BACS VACUUM HOSE (w/ BACS)

Hide 22100 14.REMOVE INJECTION PUMP

a.
A422791

Using SST, remove the injection pump drive gear set nut.

SST
09330-00021  


b.
A422792

Remove the bolt holding the injection pump to pump stay.


c.

Before removing the injection pump, check if the period lines are aligned.

If not, place new matchmarks for reinstallation.


d.
A422793

Remove the two nuts holding the injection pump to the timing gear case.


e.
A422794

Using SST, remove the injection pump.

NOTICE:
·

Tighten the two bolts more than 8 mm (0.31 in.).

·

Set SST so that it is balanced.

·

Do not hold or carry the injection pump by the adjusting lever.

·

Do not put the injection pump (with HAG, or for the 1 H D-T) at an angle more than 45° from the horizon-tal.




f.

Remove the cylinder block insulator (1PZ and 1HZ (M/T) for Europe).


g.

Remove the O-ring from the injection pump.