Home › Engine / Hybrid System › 1HZ FUEL › FUEL SENDER GAUGE ASSEMBLY
RM2850E _51 Engine / Hybrid System _073151 1HZ FUEL _0355956 FUEL SENDER GAUGE ASSEMBLY G

1HZ FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A399344E01
1.719,0.563 1.531,0.188 1.531,0.188 1.365,0.188 false 2.24,0.177 2.073,0.177 2.073,0.177 1.948,0.552 false 0.094,0.073 0.406,0.271 0.313,0.198 10 false *a 2.198,1.719 2.51,1.917 0.313,0.198 10 false *b 1.135,0.115 1.365,0.323 0.229,0.208 10 false FE 2.302,0.094 2.531,0.302 0.229,0.208 10 false FV

Apply 5 V between terminals 1 (FV) and 2 (FE).

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.


Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals



b.
A399345E02
0.365,2.063 1.031,2.063 false 1.01,0.781 1.01,1.198 false 0.302,0.708 0.719,0.708 false 0.75,4.375 1.167,4.375 false 0.115,0.104 0.427,0.302 0.313,0.198 10 false *a 0.604,4.302 0.792,4.521 0.188,0.219 10 false E 1.083,2 1.396,2.198 0.313,0.198 10 false F 0.083,0.635 0.396,0.833 0.313,0.198 10 false FR 0.917,1.229 1.229,1.427 0.313,0.198 10 false FE

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

*: The output voltage changes depending on the voltage applied to the terminals.

2 (FE) - 3 (FR) Float position is F (upper) 4.255 to 4.605 V*
Float position is E (lower) 0.345 to 0.695 V*


Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

HINT:
·

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

·

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.