Home › Engine / Hybrid System › 1HZ (LUBRICATION) › OIL PUMP
RM2850E _51 Engine / Hybrid System _073154 1HZ LUBRICATION _0355968 OIL PUMP G

1HZ LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 15133 1.INSPECT RELIEF VALVE

a.
A423103

Coat the valve with engine oil and check that it falls smoothly into the valve hole by its own weight.

If it does not, replace the relief valve. If necessary, replace the oil pump assembly.


Hide 2.INSPECT DRIVE AND DRIVEN ROTORS

a.
A423104

Inspect rotor body clearance

Using a thickness gauge, measure the clearance between the driven rotor and body.

Standard body clearance:

0.10 - 0.17 mm (0.0039 - 0.0067 in.)


Maximum body clearance:

0.20 mm (0.0079 in.)


If the body clearance is greater than maximum, replace the oil pump assembly.


b.
A423105

Inspect rotor side clearance

Using a thickness gauge and precision straight edge, measure the clearance between the rotors and precision straight edge.

Standard side clearance:

0.03 - 0.09 mm (0.0012 - 0.0035 in.)


Maximum side clearance:

0.15 mm (0.0059 in.)


If the side clearance is greater than maximum, replace the oil pump assembly.


c.
A423106

Inspect rotor tip clearance

Using a thickness gauge, measure the clearance between the drive and driven rotors.

Standard side clearance:

0.08 - 0.16 mm (0.0031 - 0.0063 in.)


Maximum side clearance:

0.21 mm (0.0083 in.)


If the tip clearance is greater than maximum, replace the oil pump assembly.