Home › Engine / Hybrid System › 1HZ STARTING › STARTER
RM2850E _51 Engine / Hybrid System _073156 1HZ STARTING _0355971 STARTER A

1HZ STARTING  STARTER  STARTER DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE FIELD FRAME WITH ARMATURE AND LEAD WIRE FROM MAGNETIC SWITCH

a.
A423150

Remove the nut, and disconnect lead wire from the magnetic switch terminal.


b.
A423151

Remove the screw, washer and the lead wire from the terminal 30.


c.
A423152

Remove the 2 through bolts and spring washers.


d.

Pull out the field frame with the armature from the magnetic switch assembly.


e.

Remove the felt washer from the rear bearing.


Hide 2.REMOVE STARTER HOUSING. CLUTCH ASSEMBLY AND GEARS

a.
A423153

Remove the 3 screws.


b.
A423154

Remove these parts from the magnetic switch assembly:

(1) Starter housing and clutch assembly

(2) Return spring

(3) Plate washer

(4) Idler gear

(5) Bearing



Hide 3.REMOVE STEEL BALL

a.
A423155

Using a magnetic finger, remove the steel ball from the clutch shaft hole.


Hide 4.REMOVE BRUSH HOLDER

a.
A423156

Remove the 2 screws and end cover from the field frame.


b.
A423157

Using a screwdriver, hold the spring tank back and disconnect the brush from the brush holder.


c.

Disconnect the 4 brushes and remove the brush holder.


Hide 5.REMOVE ARMATURE FROM FIELD FRAME