Home › Engine / Hybrid System › 1HZ STARTING › STARTER
RM2850E _51 Engine / Hybrid System _073156 1HZ STARTING _0355971 STARTER A

1HZ STARTING  STARTER  STARTER ASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Use high-temperature grease to lubricate the bearings and gears when assembling the starter.


PROCEDURE

Hide 1.PLACE ARMATURE INTO FIELD FRAME

a.
A423190

Apply grease to the armature bearings, and insert the armature into the field frame.


Hide 2.INSTALL BRUSH HOLDER

a.

Place the brush holder on the armature.


b.
A423191

Using a screwdriver, hold the brush spring back, and connect the brush into the brush holder. Connect the four brushes.

NOTICE:

Check that the pOllltive (+) lead wires are not grounded.



c.
A423192

Install the end cover to the field frame with the 2 screws.


Hide 3.INSERT STEEL BALL INTO CLUTCH SHAFT HOLE

a.

Apply grease to the steel ball.


b.

Insert the steel ball into the clutch shaft hole.


Hide 4.INSTALL STARTER HOUSING, CLUTCH ASSEMBLY AND GEAR

a.
A423193

Apply grease to the return spring.


b.

Insert the return spring into the magnetic switch hole.


c.

Install the plate washer to the magnetic switch.


d.
A423194

Place these parts to the starter housing:

(1) Idler gear

(2) Bearing



e.
A423195

Assemble the starter housing and magnetic switch assembly and install the 3 screws.


Hide 5.INSTALL FIELD FRAME WITH ARMATURE AND LEAD WIRE TO MAGNETIC SWITCH

a.
A423196

Install a new felt washer to the armature.


b.
A423197

Align the protrusion of the field frame with the cutout of the magnetic switch.


c.
A423198

Install the field frame and armature assembly with the 2 through bolts.

Torque:

9.3 N*m (95 kgf*cm, 82 in.*lbf)



d.
A423199

Install the lead wire to terminal 30 with the screw and washer.

Torque:

3.8 N*m (41 kgf*cm, 32 in.*lbf)



e.
A423200

Connect the lead wire to terminal C, and install the nut.

Torque:

21.1 N*m (215 kgf*cm, 16 ft*lbf)