Home › Engine / Hybrid System › 1HZ STARTING › STARTER
RM2850E _51 Engine / Hybrid System _073156 1HZ STARTING _0355971 STARTER A

1HZ STARTING  STARTER  MAGNETIC SWITCH TERMINAL KIT PARTS REPLACEMENT  


PROCEDURE

Hide 1.REMOVE MAGNETIC SWITCH END COVER

a.
A423182

Remove the 3 bolts, lead clamp, end cover, gasket and plunger.


Hide 2.INSPECT CONTACT PLATE FOR WEAR

a.
A423183

Using vernier calipers, measure the contact plate for depth of wear.

Maximum wear:

0.9 mm (0.035 in.)


If the depth of wear is greater than the maximum, replace the contact plate.


Hide 3.REMOVE TERMINAL KIT PARTS

a.
A423184

Using SST. loosen the terminal nuts.

SST
09810-38140  


b.

Terminal C:

Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).


c.

Terminal 30:

Remove the terminal nut, wave washer, terminal insulator (outside), packing, O-ring, terminal bolt, contact plate, terminal insulator (inside) and insulation paper.


Hide 4.REINSTALL TERMINAL KIT PARTS

a.

Install these new parts:

Terminal 30:

A423185


(1) Insulation paper

(2) Terminal insulator (inside)

(3) Contact plate

(4) Terminal bolt

(5) O-ring

(6) Packing and terminal insulator (outside)

Install the packing to the terminal insulator. and install them.

HINT:

Match the protrusion of the insulator with the indentation of the housing.


(7) Wave washer

(8) Terminal nut

NOTICE:

Be careful to install the terminal insulators (Inside) and wave washers in the correct direction.



Terminal C:

A423186


(1) Terminal insulator (inside)

(2) Contact plate

(3) Terminal bolt

(4) O-ring

(5) Terminal insulator (outside)

(6) Wave washer

(7) Terminal nut

NOTICE:

Be careful to install the terminal insulators (inside) and wave washers in the correct direction.




b.

Temporarily tighten the terminal nuts.


Hide 5.TIGHTEN TERMINAL NUT

a.
A423187

Put a wooden block on the contact plate and press it down with a hand press.

Dimensions of wooden block:

20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)


Press force:

981 N (100 kgf, 221 lbf)


NOTICE:
·
A429856

Check the diameter of the hand press ram. Then calculate the gauge pressure of the press when 981 N (100 kgf, 221 lbf) of force is applied.

·

If the contact plate is not pressed down with the specified pressure, the contact plate may tilt due to coil deformation or the tightening of the nut.




b.
A423188

Using SST, tighten the nuts to the specified torque.

SST
09810-38170  

Torque:

Terminal C and Terminal 30

29.9 N*m (305 kgf*cm, 22.1 ft*lbf)


NOTICE:

If the nut is over tightened, it may cause cracks on the inside of the insulator.



Hide 6.CLEAN CONTACT SURFACES OF CONTACT PLATE AND PLUNGER

a.
A423189

Clean the contact surfaces of the remaining contact plate and plunger with a dry shop rag.


Hide 7.REINSTALL MAGNETIC SWITCH END COVER

a.

Install the plunger, new gasket, end cover and lead clamp with the 3 bolts.

Torque:

2.55 N*m (26 kgf*cm, 23 in.*lbf)