1.INSPECT RELAY CONTINUITY
LOCATION: In the engine compartment on the left side.
Using an ohmmeter, check that there is continuity between terminals E and ST.
Check that there is no continuity between terminals B and MG.
If continuity is not as specified, replace the relay.
2.INSPECT RELAY OPERATION
LOCATION: In the engine compartment on the left side.
Apply battery voltage across terminals E and ST.
If the vehicle has a voltage coverter, per-form the check using a 12 V battery.
Using an ohmmeter, check that there is continuity between terminals B and MG.
If operation is not as specified, replace the relay.