1.INSPECT RELAY CONTINUITY
LOCATION: In the engine compartment on the left side.
Using an ohmmeter, check that there is continuity between terminals e and g.
Check that there is continuity between terminals 1 - and E.
Check that there is continuity between terminals 1 + and 2+.
Check that there is no continuity between terminals 1 - and 2+.
If continuity is not as specified, replace the relay.
2.INSPECT RELAY OPERATION
LOCATION: In the engine compartment on the left side.
Apply battery voltage across terminals e and g.
Using an ohmmeter, check that there is continuity between terminals 1 - and 2+.
Check that there is no continuity between terminals 1 + and 2+.
Check that there is no continuity between terminals 1 - and E.
If operation is not as specified, replace the relay.