Home › Engine / Hybrid System › N04C-VL (ENGINE MECHANICAL) › DRIVE BELT
RM2850E _51 Engine / Hybrid System _073160 N04C-VL ENGINE MECHANICAL _0356000 DRIVE BELT G

N04C-VL ENGINE MECHANICAL  DRIVE BELT  INSPECTION  


PROCEDURE

Hide 1.INSPECT V BELT

a.

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V belt.

HINT:
·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.




b.

Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley.


If it has slipped out, replace the V belt. Install a new V belt correctly.