22100
1.INSPECT INJECTION OR SUPPLY PUMP ASSEMBLY
Check the suction control valve.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 1.9 to 2.3 Ω |
| *1 | Suction Control Valve |
| *a | Component without harness connected (Injection or Supply Pump Assembly) |
If the resistance is not as specified, replace the fuel supply pump.
Check the fuel temperature sensor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 2.21 to 2.69 kΩ |
| 1 - 2 | 80°C (176°F) | 0.287 to 0.349 kΩ |
If the resistance is not as specified, replace the fuel supply pump.
| *a | Resistance |
| *b | Temperature |
| *c | Component without harness connected (Injection or Supply Pump Assembly) |