84461B
1.INSPECT LEVEL WARNING SWITCH
Check the level warning switch resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | ON | Below 1 Ω |
| 1 - 2 | OFF | 10 kΩ or higher |
| *a | Component without harness connected (Level Warning Switch) |
| *b | ON |
| *c | OFF |
If the result is not as specified, replace the level warning switch.
2.INSPECT CLOGGING SWITCH
Measure the resistance between the terminals.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | Below 1 Ω |
| *a | Component without harness connected (Clogging Switch) |
If the result is not as specified, replace the fuel filter assembly.