Home › Engine / Hybrid System › N04C-VL (COOLING) › COOLING SYSTEM
RM2850E _51 Engine / Hybrid System _073164 N04C-VL COOLING _0356020 COOLING SYSTEM G

N04C-VL COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

a.

Remove the radiator cap sub-assembly.

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.



b.
A393003E01
0.5,1.813 0.5,1.646 0.5,1.646 0.875,1.365 false 0.417,1.813 0.729,2.01 0.313,0.198 10 false *a

Fill the radiator assembly with coolant and attach a radiator cap tester.

Text in Illustration
*a Radiator Cap Tester


c.

Warm up the engine.


d.

Pump it to 137 kPa (1.4 kgf/cm2, 19.9 psi), then check that the pressure does not drop.

If the pressure drops, check the hoses, radiator assembly and water pump assembly for leakage. If there are no signs of external coolant leakage, check the heater core, cylinder block and cylinder head.


e.

Reinstall the radiator cap.


Hide 2.CHECK COOLANT LEVEL OF RESERVOIR

a.
A402092

The engine coolant should be between the LOW and FULL lines when the engine is cold.

If low, check for leakage and add TOYOTA SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology up to the FULL line.


Hide 3.CHECK ENGINE COOLANT QUALITY

a.

Remove the radiator cap sub-assembly.

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.



b.

Check for any excessive deposits of rust or scale around the radiator cap sub-assembly and radiator filler hole; the coolant should be free of oil.

If excessively dirty, replace the coolant.


c.

Reinstall the radiator cap sub-assembly.