Home › Engine / Hybrid System › N04C-VL (COOLING) › RADIATOR
RM2850E _51 Engine / Hybrid System _073164 N04C-VL COOLING _0356025 RADIATOR G

N04C-VL COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16520A 1.INSPECT RADIATOR CAP SUB-ASSEMBLY

a.
A138101

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the parts with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that rubber packings 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.
Z000570E11
1.625,0.927 1.75,0.438 true 0.396,0.948 0.396,1.469 true 1.677,0.25 1.99,0.448 0.313,0.198 10 false *1 0.344,1.51 0.656,1.708 0.313,0.198 10 false *2 1.479,1.135 1.792,1.333 0.313,0.198 10 false *a

When using the cap tester, tilt it to more than 30 degrees.

Text in Illustration
*1 Radiator Cap Tester
*2 Radiator Cap
*a 30° or More


vi.

Pump the cap tester several times, and check the maximum pressure *1.

Pumping speed:

1 pump per second.


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgement criteria:
Item Specified Condition

If the maximum pressure is less than the minimum standard value, replace the radiator cap sub-assembly.

Standard value (for brand new cap) 93 to 123 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (after using cap) 78 kPa (0.8 kgf/cm2, 11.4 psi)