1.DRAIN ENGINE COOLANT (w/ ACSD)
2.REMOVE INJECTION PIPES
3.DISCONNECT HOSES
Disconnect these hoses:
2 fuel return hoses
BU:
Vacuum hose (for A/C idle-up)
BU:
Vacuum hose (for PS idle-up)
Boost compensator hose
w/ ACSD:
Disconnect the 2 water bypass hoses from the thermo wax.
w/ ACSD:
Remove the 2 bolts, and disconnect the water bypass pipe from the intake manifold.
22100
4.REMOVE INJECTION PUMP
Disconnect the injection pump connector.
Disconnect the accelerator cable (15B-FT) or accelerator link (Others) from the injection pump.
Remove the 4 bolts and injection pump stay.
Before removing the injection pump, check if the matchmarks are aligned. If not, place new matchmarks for reinstallation.
Remove the 2 nuts and injection pump.
Remove the O-ring from the injection pump flange.