Home › Engine / Hybrid System › 14B (FUEL) › FUEL INJECTION NOZZLE › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073168 14B FUEL _0356040 FUEL INJECTION NOZZLE A

14B FUEL  FUEL INJECTION NOZZLE  INJECTION NOZZLES CLEANING AND INSPECTION  


PROCEDURE

Hide 1. NOZZLES CLEANING

a.

To wash the nozzles, use a wooden stick and brass brush. Wash them in clean diesel fuel.

HINT:

Do not touch the nozzle mating surfaces with your fingers.



b.
A424203

Using a wooden stick, remove the carbon adhering to the nozzle needle tip.


c.
A424204

Using a brass brush, remove the carbon from the exterior of the nozzle body (except lapped surface).


d.

Check the nozzle body for burns or corrosion.


e.

Check the nozzle needle tip for damage or corrosion.

If any of these conditions are present, replace the nozzle assembly.


Hide 2.INSPECT NOZZLE ASSEMBLY

a.

Wash the nozzle in clean diesel fuel.

HINT:

Do not touch the nozzle mating surfaces with your fingers.



b.
A424205

Tilt the nozzle body about 60 degrees and pull the needle out about one third of its length.


c.
A424206

When released, the needle should stick down into the body vent smoothly by its own weight.


d.

Repeat this test, rotating the needle slightly each time.

If the needle does not sink freely, replace the nozzle assembly.