Home › Engine / Hybrid System › 14B (COOLING) › COOLANT › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073169 14B COOLING _0356045 COOLANT A

14B COOLING  COOLANT  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

a.
A424222

Remove the radiator cap from the water filler (BB) or water outlet (BU).

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot, as fluid and steam can be blown out under pressure.



b.

Loosen the radiator drain plug (on the radiator lower tank) and engine drain plug (on the cylinder block), and drain the coolant.


c.

Close the drain plugs.

Torque (Engine):

24.5 N*m (250 kgf*cm, 18 ft*lbf)



Hide 2. FILL ENGINE COOLANT

a.

Slowly fill the system with coolant.

·

Use a good brand of ethylene-glycol base coolant and mix it according to the manufacturer's directions.

·

Using coolant which includes more than 50 % ethylene-glycol (but not more than 70 %) is recommended.


NOTICE:
·

Do not use an alcohol type coolant.

·

The coolant should be mixed with demineralized water or distilled water.



Coolant capacity (liters (US qts, Imp. qts)):
BB

*: Vehicles with cold weather package

3B w/ Front and rear heaters 14.6 (15.4, 12.8)
14B w/ Front and rear heaters 14.2 (15.0. 12.5)
w/ Front and rear heaters 15.6 (16.5, 13.7)*
w/ Front heater 13.0 (13.7, 11.4)
w/o Heater 11.0 (11.6, 9.7)

BU (Regular cab)
3B w/ Front and rear heaters 13.3 (14.1, 11.7)
w/ Front heater 12.9 (13.6, 11.4)
w/o Heater 11.8 (12.6, 10.4)
14B w/ Heater Except G.C.C. 12.6 (13.3, 11.0)
w/o Heater G.C.C. 11.8 (12.4, 10.3)
w/o Heater Except G.C.C. 11.5 (12.1, 10.1)
15B-F w/ Heater 12.2 (12.9, 10.7)
w/o Heater 11.1 (11.7, 9.8)

BU (Wide cab)
14B w/ Heater 13.0 (13.7, 11.4)
w/o Heater 11.9 (12.6, 10.5)
15B-F w/ Heater 12.8 (13.3, 11.1)
w/o Heater 11.5 (12.2, 10.1)
15B-FT w/ Heater 13.5 (14.3, 11.9)
w/o Heater 12.4 (13.1, 10.9)



b.

Install the radiator cap.


c.

Start the engine, and bleed the cooling system.

·

Open the heater water valve.

·

Warm up the engine.

·

Stop the engine, and wait until the engine coolant cools down.

·

Refill the radiator reservoir with coolant until it reaches the "FULL" line.



Hide 3.CHECK ENGINE COOLANT FOR LEAKS