Home › Engine / Hybrid System › 14B (COOLING) › RADIATOR › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073169 14B COOLING _0356048 RADIATOR A

14B COOLING  RADIATOR  RADIATOR INSPECTION  


PROCEDURE

Hide 1.REMOVE RADIATOR CAP FROM WATER FILLER (BB)

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot, as fluid and steam can be blown out under pressure.


Hide 2.INSPECT RADIATOR CAP (BB)

NOTICE:
A424235

·

If the radiator cap contains water or foreign substances, always rinse it with water.

·

When performing steps (a) and (b) below, keep the radiator pump tester at an angle of over 30° above the horizontal.



a.

Using a radiator cap tester, slowly pump the tester and check that air is coming from the relief valve.

Pump speed:

1 push/3 seconds or more


NOTICE:

Push the pump at a constant speed.


If air is not coming from the relief valve, replace the radiator cap.


b.

Pump the tester several times and measure the relief valve opening pressure.

Standard opening pressure:

74 - 103 kPa

(0.75 - 1.06 kgf/cm2, 10.7 - 14.9 psi)


Minimum opening pressure:

59 kPa (0.6 kgf/cm2, 8.5 psi)


HINT:

Use the tester's maximum reading as the opening pressure.


If the opening pressure is less than minimum, replace the radiator cap.


Hide 3.INSPECT COOLING SYSTEM FOR LEAKS (BB)

a.
A430588

Fill the radiator with coolant, and attach a radiator cap tester to the water filler.


b.

Warm up the engine.


c.

Pump it to 118 kPa (1.2 kgf/cm2, 17.1 psi), and check that the pressure does not drop.

If the pressure drops, check the hoses, radiator or water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.


Hide 4.REINSTALL RADIATOR CAP (BB)

Hide 5.REMOVE RADIATOR CAP FROM WATER OUTLET (BU)

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot, as fluid and steam can be blown out under pressure.


Hide 6.INSPECT RADIATOR CAP (BU)

NOTICE:
A424236

If the radiator cap contains water or foreign substances, always rinse it with water.


a.

Using a radiator cap tester. pump the tester and measure the relief valve opening pressure.

Standard opening pressure:

74 - 103 kPa

(0.75 - 1.05 kgf/cm2, 10.7 - 14.9 psi)


Minimum opening pressure:

59 kPa (0.6 kgf/cm2, 8.5 psi)


HINT:

Use the tester's maximum reading as the opening pressure.


If the opening pressure is less than minimum, replace the radiator cap.


Hide 7.INSPECT COOLING SYSTEM FOR LEAKS (BU)

a.
A424237

Fill the radiator and engine with coolant, and attach a radiator cap tester to the water outlet.


b.

Warm up the engine.


c.

Pump it to 118 kPa (1.2 kgf/cm2, 17.1 psi), and check that the pressure does not drop.

If the pressure drops, check the hoses, radiator or water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.


Hide 8.REINSTALL RADIATOR CAP (BU)